(2019-11-14, 21:49)Roland Melkert Wrote: As for spools I'm thinking about a third control point for those so they can be generated based on a single set of parameters (bit like springs).Speaking of springs (and spools) it would be nice to have the possibility to create a LQ version, cylinder segments based (smaller size, direct compatibility with Studio renderer)
LDCad—Tying the knot
« Next Oldest | Next Newest »
| Messages In This Thread |
|
LDCad—Tying the knot - by N. W. Perry - 2019-11-13, 0:57
RE: LDCad—Tying the knot - by Roland Melkert - 2019-11-13, 19:43
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-14, 15:33
RE: LDCad—Tying the knot - by Philippe Hurbain - 2019-11-14, 17:26
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-14, 19:13
RE: LDCad—Tying the knot - by Roland Melkert - 2019-11-14, 21:49
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-15, 6:30
RE: LDCad—Tying the knot - by Philippe Hurbain - 2019-11-15, 8:00
RE: LDCad—Tying the knot - by Roland Melkert - 2019-11-15, 20:25
RE: LDCad—Tying the knot - by Willy Tschager - 2019-11-15, 20:29
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-15, 23:19
RE: LDCad—Tying the knot - by Max Martin Richter - 2019-11-15, 23:32
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-18, 4:42
RE: LDCad—Tying the knot - by Roland Melkert - 2019-11-21, 23:26
RE: LDCad—Tying the knot - by N. W. Perry - 2019-11-23, 1:36
|
Users browsing this thread: 1 Guest(s)