Test part issues


Test part issues
#1
Photo 
Just made a simple test part in LDPC,
I used the triangular shield template, filled out some meta data, its not accurate but I don't care its just a test. Through it in the following folders one at a time to try and get it to be available in LDcad.
LDraw/Parts
LDraw/Parts/s
Unoffical/Parts
Unofficial/parts/s

I opened it in LDCad using the 'Open' option but then its on its own page as a .dat file

I also exported one without meta-data earlier in. Any ideas why these parts can't be found in the library?


Edit: LDCad was referencing a Zip file not the folders.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Test part issues - by End Unsure - 2019-10-28, 0:59

Forum Jump:


Users browsing this thread: 1 Guest(s)