Concerning "classic" hoses and LDCad


RE: Concerning "classic" hoses and LDCad
#3
(2019-10-21, 23:19)Roland Melkert Wrote: I don't think there is an official non beveled version of 165.dat

You could make one yourself and place it in the donors folder "%appdata%\LDCad\donors"

Hmm, I wonder if I could use the end piece from LSynth (ls20.dat)?

EDIT: Or better yet, edit the existing end cap for the 3mm hose and make it 4mm? Although, I'm not really sure what I'm doing there, as I haven't delved into parts authoring much at all.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Concerning "classic" hoses and LDCad - by N. W. Perry - 2019-10-22, 0:49

Forum Jump:


Users browsing this thread: 1 Guest(s)