need help with chains


RE: need help with chains
#6
(2019-08-07, 21:11)Johann Eisner Wrote: Hi again
Quick and dirty solution, maybe not the correct way, but it works.
Open your file with Editor
Edit ---> Replace...
Search: 30104k01.dat
Replace with: 208.dat

Search: 30104k02.dat
Replace with: 209.dat

Save the file.
Enjoy!
Yes, Studio must have all parts in is library to properly show them - and 30104kxx is not. So you can either replace the missing part with a known equivalent as Johann proposed to do, or put the missing parts in studio CustomParts folder.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
need help with chains - by Stefan Weinert - 2019-08-07, 15:07
RE: need help with chains - by Johann Eisner - 2019-08-07, 19:44
RE: need help with chains - by Stefan Weinert - 2019-08-07, 20:31
RE: need help with chains - by Johann Eisner - 2019-08-07, 20:40
RE: need help with chains - by Johann Eisner - 2019-08-07, 21:11
RE: need help with chains - by Philippe Hurbain - 2019-08-08, 7:41
RE: need help with chains - by Stefan Weinert - 2019-08-08, 14:06
RE: need help with chains - by Stefan Weinert - 2019-08-08, 14:18
RE: need help with chains - by Roland Melkert - 2019-08-08, 16:57
RE: need help with chains - by Stefan Weinert - 2019-08-09, 14:59

Forum Jump:


Users browsing this thread: 1 Guest(s)