Find and replace a part in LDCad

RE: Find and replace a part in LDCad
(2019-04-11, 18:25)Johann Eisner Wrote: Suppose I have installed a wrong part in a model, how can I find and replace it the fastest?

I know which part is wrong, but I know neither the step nor the submodel where it was installed.


A method that works (maybe there is an easier way):
- go to nested mode to be able to access into submodels
- add a part of the same type you want to find
- select -> same part
- select -> invert
- hide
- go to normal mode
- select the wrong part. The submodel containing it will be displayed in status bar. You may also use stepping menu -> selected to go to the step where this submodel was added.
« Next Oldest | Next Newest »

Messages In This Thread
RE: Find and replace a part in LDCad - by Philippe Hurbain - 2019-04-11, 18:58

Forum Jump:

Users browsing this thread: 1 Guest(s)