Description of part 33909

[Jaco van der Molen]

+1


We already have:
3794b.dat,  Plate  1 x  2 with Groove with 1 Centre Stud
15573.dat,  Plate  1 x  2 with Groove with 1 Centre Stud, without Understud
34103.dat,  Plate  1 x  3 with  2 Studs Offset
92593.dat,  Plate  1 x  4 with Two Studs
18674.dat,  Plate  2 x  2 Round with  1 Centre Stud
87580.dat,  Plate  2 x  2 with Groove with 1 Centre Stud

Change:
24445.dat,  Plate  1 x  2 with 1 Tall Centre Stud                ( Tile  1 x  2 with 1 Tall Centre Stud )
98549.dat,  Plate  2 x  2 with Bar and Stud with Stop Ring  ( Tile 2 x  2 with Bar and Stud with Stop Ring )
33909.dat,  Plate  2 x  2 with 2 Studs on Edge                   ( Tile 2 x  2 with Studs on Edge )
88646.dat,  Plate  3 x  4 with 4 Studs                                ( Tile 3 x  4 with Four Studs )
6179.dat,    Plate  4 x  4 with 4 Studs on Edge                   ( Tile 4 x  4 with Studs on Edge )
6180.dat,    Plate  4 x  6 with 12 Studs on Edges                ( Tile 4 x  6 with Studs on Edges )
4607.dat,    Plate  4 x 16 with 24 Studs                             ( Tile 4 x 16 with 24 Studs )
6178.dat,    Plate  6 x 12 with 16 Studs on Edges               (Tile  6 x 12 with Studs on Edges )


What parts have I missed?

What about:
6177.dat "Tile 8 x  8 Round with  2 x  2 Center Studs"?  Plate or Tile?

Ok, I think that about covers it.
We could look at all tiles that are not entirely flat, but that would leave "pure" tiles only described as tiles.
A.k.a. Tile 1x1, 1x2, 1x3, 1x4, 1x6, 1x8, 2x2, 2x3, 2x4