Howto treat submodel as inlined in LPub3D


Howto treat submodel as inlined in LPub3D
#1
Hi all,

Sometimes I use small and deeply nested submodels just to make it easier to handle coordinate system transformations. For example, I might just put a liftarm and a pin into a submodel so that I can move them around together.

In these cases it is not always useful to show the submodel as a submodel in the building instructions. Hence, I would like to treat the submodel as inlined in LPub3D. However, I cannot find an option to achieve this. I can choose "Convert to callout", which can sometimes be used as a workaround, but not always, specifically with nested submodels. I can "Ignore this submodel", which does almost achieve what I want except that the parts are then also removed from the PLI. Or I can "Treat as part", which also almost does what I want except that the submodel is shown assembled in the PLI. What I need is something like "Treat as inlined". Is this possible somehow?

Thanks for your help
Lutz
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Howto treat submodel as inlined in LPub3D - by Lutz Gehlen - 2019-04-06, 19:08

Forum Jump:


Users browsing this thread: 1 Guest(s)