Lpub How to add a submodel render in building isntruction


RE: Lpub How to add a submodel render in building isntruction
#10
(2018-10-26, 19:02)Johann Eisner Wrote:
(2018-10-26, 17:42)tatubias Wrote: For the model image. its faster.  for buffer exchange i use it as it should with buffer exchange.

[Image: 04JHV4E.png]

the only thing that using the image you have at least 2 ways.

1 - take a screenshot from 3dviewer from lpub3d then send it to a image editor and add the border. The bad thing there is that the screenshot its low quality allways.

2 - the other way is to open the file get the sub model, export it and open it on ldview. then export the hi res image to the photo editor software and make the image with the border. as its in the picture upper. but its also lot of work.

its a pitty that lpub3d in the viewer does not brings an option to export the 3d view into a png file with the possibility to set the dpi, background color or transparent background.

Hi
You do not have to go over the detour with the export, so you can open the subfile in LDView. Select "Tools" ---> "MPD Model Selection" ---> in the menu bar and then the subfile you need. If you change the manual in between, you can reload the model with "Reload" in the File menu or with F5.

Tha k hoy very muuuuuy have I did not realize that it was available that option . You made me save loooots of editing hours.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Lpub How to add a submodel render in building isntruction - by Victor Di Rienzo - 2018-10-26, 20:20

Forum Jump:


Users browsing this thread: 1 Guest(s)