LDCAD compass location


RE: LDCAD compass location
#15
(2018-09-21, 20:02)Roland Melkert Wrote:
(2018-09-21, 19:51)Kathleen Kampf Wrote: Thanks, I tried this today. I was able to form my figure 8 but, part of it appears flat like tape and another portion looks wrinkled. I am happy it's twisted now.

You need to make sure the 'roll' orientation is correct when using the bezier points. It's indicated by the red/blue arrows. The difference between two connected ones should be less then 180 degrees or the underneath math will do funny things Smile

I don't understand 'roll' orientation nor how to use the bezier points. Also, how do you update LDRAW parts?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
LDCAD compass location - by Kathleen Kampf - 2018-09-03, 19:34
RE: LDCAD compass location - by Owen Dive - 2018-09-04, 7:20
RE: LDCAD compass location - by Kathleen Kampf - 2018-09-26, 12:31

Forum Jump:


Users browsing this thread: 1 Guest(s)