One dapper torso


RE: One dapper torso
#10
(2018-02-19, 0:23)Willy Tschager Wrote:
(2018-02-18, 17:22)Aimee Wrote: OK, I've got this far

For a first pattern in LDPC this is a remarkable work, well done. I'd say - if critics is allowed - that it has even too much detail. Consider also to enclose the buttons ( say discs and rings) in X-Xndis.dat (negative discs) via Add Primitive -> LDraw Primitives -> Inverse of Circular Disc Sector. Check out 973pw4.dat - Minifig Torso with Sheriff Pattern.

w.

It's alright. I really hope it never needs subdividing though, the triangulation is pretty horrible in places. And thank god it's all on one plane, the phong shading would be wild :9
Reply
« Next Oldest | Next Newest »



Messages In This Thread
One dapper torso - by Aimee - 2018-02-12, 6:35
RE: One dapper torso - by Philippe Hurbain - 2018-02-12, 8:14
RE: One dapper torso - by Aimee - 2018-02-18, 17:22
RE: One dapper torso - by Philippe Hurbain - 2018-02-18, 17:33
RE: One dapper torso - by Steffen - 2018-02-18, 17:51
RE: One dapper torso - by Aimee - 2018-02-18, 19:22
RE: One dapper torso - by Philippe Hurbain - 2018-02-18, 19:29
RE: One dapper torso - by Aimee - 2018-02-19, 7:28
RE: One dapper torso - by Willy Tschager - 2018-02-19, 0:23
RE: One dapper torso - by Aimee - 2018-02-19, 7:29
RE: One dapper torso - by Aimee - 2018-02-19, 8:21
RE: One dapper torso - by Johann Eisner - 2018-02-19, 21:03
RE: One dapper torso - by Willy Tschager - 2018-02-19, 23:50
RE: One dapper torso - by Aimee - 2018-02-20, 3:37
RE: One dapper torso - by Magnus Forsberg - 2018-02-19, 22:09
RE: One dapper torso - by Aimee - 2018-02-21, 12:48
RE: One dapper torso - by Philippe Hurbain - 2018-02-21, 14:12
RE: One dapper torso - by Aimee - 2018-02-21, 20:35
RE: One dapper torso - by Willy Tschager - 2018-02-21, 14:27
RE: One dapper torso - by Philippe Hurbain - 2018-02-21, 15:02
RE: One dapper torso - by Magnus Forsberg - 2018-10-23, 15:19
RE: One dapper torso - by Nils Schmidt - 2018-02-20, 21:01
RE: One dapper torso - by Aimee - 2018-02-21, 12:49

Forum Jump:


Users browsing this thread: 2 Guest(s)