Tile with C-Clip - Part 15712 - Thickness


RE: Tile with C-Clip - Part 15712 - Thickness
#4
(2017-12-28, 23:00)Gerald Lasser Wrote:
(2017-12-28, 22:43)Magnus Forsberg Wrote: As being the author of 15712, no. How does it differ? I don't understand.

The surface, which is currently at Y=0, is in real life at Y=0.5

I made a mock up for the part I wanted to author and built a holder with the clips from real parts. It struck me that I had quite a big gap with the real thing where there was non in the digital parts.

You barely notice it when you place them in a MOC, but using them as a 'measuring instrument' you notice the difference between the old and the new part.

My calipers tell me the old one is 3.2 mm whereas the new one is just 3 mm. I need to check more of them tomorrow.

I took about 10 pieces and they are all 0,2 mm thinner than the old part. Is it worth to change?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Tile with C-Clip - Part 15712 - Thickness - by Gerald Lasser - 2017-12-29, 12:56

Forum Jump:


Users browsing this thread: 1 Guest(s)