Can't Scale Callout LPUB4


Can't Scale Callout LPUB4
#1
I've been using both the official LPUB 4.0.0.10 from Sourceforge and LPUB 4.0.0.12 compiled by Ramón as mentioned in a previous thread. Here is my issue, I have a set of directions that start with a submodel x2. Then it is finished with the taking the the 2 submodels and connecting them with some additional pieces. (File attached) My issue is that when I do "Add assembled image to parent page", It gives me a callout appropriately on pg 12, counting the cover. The callout is WAY too big, but there is no way to scale it. When I right click on the assembly in the callout, and choose "change scale" the callout doesn't change.

Does anyone know how to fix this? I'm assuming there are some metacommands I put right in the file, but I looked through the list of metacommands from the help menu, and couldn't figure it out.

Thanks!

Chris Eyerly


Attached Files
.ldr   Micro Tower Bridge - Full-b.ldr (Size: 6.73 KB / Downloads: 2)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Can't Scale Callout LPUB4 - by Chris Eyerly - 2011-12-09, 16:25

Forum Jump:


Users browsing this thread: 1 Guest(s)