Part and decals request: Insectoids, UFO, Stingray

[Philippe Hurbain]

Do you know if the printed area is raised or recessed? We might need to adapt the part 30231 first. The part at PT is not made correct yet.

You say in your first post "decal", but this is a printed pattern. Right?

Sooo... I made a deep search in my oddball parts, and found again a pair of large insectoid wings. Structure is fully symmetrical (so the left/right version depend only on the side where the print is applied). No rise or recess for the pattern. The line that appears of the model of the small wing present on PT materialize the polishing difference: middle patternable area is shiny, border is grainy, slope brick style (but finer grain). Dunno if we can do something about this...