Parts that do not quite fit together


RE: Parts that do not quite fit together
#3
(2017-02-07, 17:53)Merlijn Wissink Wrote: I just tried this in LDcad and they look perfectly fine here. No problems whatsoever...
Both are perfectly aligned here too. But if you look at 32028.dat you see "0 !HISTORY 2009-01-02 [anathema] Corrected dimensions of tongue, optimised a bit", so... are you sure that your library is fully up to date?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: Parts that do not quite fit together - by Philippe Hurbain - 2017-02-07, 18:39

Forum Jump:


Users browsing this thread: 1 Guest(s)