Sloped brick with Batman logo

Sloped brick with Batman logo
I'm looking for an LDraw version of this part:

I found this part (973pb0a.dat) that has the Batman logo, but how do I extract just the Batman logo from the dat file (I was thinking I could just create a sticker part and lay it on top of the slope brick).

I also found this sticker part (4297014a.dat), but the logo is to big for the slope brick - is there a way to easily scale this logo to make it smaller?

What's the best tool for selecting/extracting certain parts of an existing part file? (other than Notepad++)
« Next Oldest | Next Newest »

Messages In This Thread
Sloped brick with Batman logo - by Reuben Pearse - 2017-01-04, 7:53

Forum Jump:

Users browsing this thread: 1 Guest(s)