For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1


RE: For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1
#11
(2016-08-15, 7:27)Owen Dive Wrote: Right, but my point was that if you wanted to use more than 6 different categories, you can. You can add another whole part bin window, which gives you six more bins, and you can have two of them displayed at the same time. In my setup, I have a window (6 bins) for studless technic, another window (6 more bins) for studded technic, and a third window (for a total of 18 bins) for everything else - which I mostly use for submodels and misc. non-technic parts. I just wanted to make sure you knew you could do that.

Instead of a screenshot, I see "Image: " then a filename, surrounded by [].

Thanks for the info.  I didn't realize that you could have multiple part bins open at the same time.

I'm digging out my Great Ball Contraption modules to test and pack for Bricks By the Bay in Santa Clara, California this weekend, so will get back to LDCad late next week.

Walt
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: For Beginners: LDCad 1.5 Part Bins for EV3 Education 45544-1 - by Walt White - 2016-08-17, 3:22

Forum Jump:


Users browsing this thread: 1 Guest(s)