LDCad 1.6 Alpha 4 (win+linux)

RE: LDCad 1.6 Alpha 4 (win+linux)
Hey, I found a small annoyance in LDcad.
I got a new mouse a few days ago, the Logitech MX master. It has a scroll-wheel that has 2 modes, a clicking mode (like a normal scroll-wheel) and a free mode in which you can give it a push and it keeps turning for a while (it has no resistance). It's really nice and even after just a few days I love that feature.

However, LDCad doesn't play too nice with it. Well, it works, but not optimally. When I'm in the source-editor and give the scroll-wheel a good push, it scrolls super slow. Well, not slower than with a 'normal' mouse, but also not faster. It just goes up or down line by line, while I expected the lines to swoosh by. For comparison: when I give the mouse-wheel a hard swing in e.g. Excel, I'm at row 10000+ in mere seconds. The part bin has the same problem, although it works better, it scrolls a little faster than the source window.

I hope I explained it well, I know it may sound a little vague. I can make a little video of it if you'd like.
« Next Oldest | Next Newest »

Messages In This Thread
RE: LDCad 1.6 Alpha 4 (win+linux) - by Merlijn Wissink - 2016-11-12, 9:01

Forum Jump:

Users browsing this thread: 1 Guest(s)