RE: LPub3D 2.0 Released
2017-05-03, 13:47 (This post was last modified: 2017-05-03, 14:01 by Merlijn Wissink.)
2017-05-03, 13:47 (This post was last modified: 2017-05-03, 14:01 by Merlijn Wissink.)
I have the feeling this problem is kinda related to the one above. I have a 'raw' LDraw file without any LPub commands. I open it in LPub3D and set the page to A4 landscape. Everything looks fine in the editor, but the exported pdf is in A4 portrait 
Not the whole pdf though, the very last page is in landscape. The LDraw is still a WIP. It has a bunch of submodels that are all thrown together in the main model at the last page (so the main model has just 1 'step'). The instructions start at a submodel. Maybe that has something to do with the problem?
Also, the pdf is in portrait mode, but you can clearly see that the thing it was trying to export was landscape and has been cut off to portrait again.
The weirdest thing to me still, is how the editor can show the page correctly in landscape, while the pdf export is in portrait. How does that happen?
Not the whole pdf though, the very last page is in landscape. The LDraw is still a WIP. It has a bunch of submodels that are all thrown together in the main model at the last page (so the main model has just 1 'step'). The instructions start at a submodel. Maybe that has something to do with the problem?
Also, the pdf is in portrait mode, but you can clearly see that the thing it was trying to export was landscape and has been cut off to portrait again.
The weirdest thing to me still, is how the editor can show the page correctly in landscape, while the pdf export is in portrait. How does that happen?