WeDo


RE: 45300 - WeDo 2.0 - Milo with Tilt Sensor
#8
(2021-02-23, 20:14)KYLE Wrote: Hello Philippe, sorry for not answering before, the university is taking all my time, here you have the model Thank you
The problem was (relatively) simple... You used HQ templates for Wedo elements, this generates a 3D mesh for the cables, and embeds this mesh in the file. Unfortunately Studio doesn't like these embedded parts Sad
The solution was to use LQ version, that use short segments of cable. Since these short segments are included in Studio library, it works well.
After that, remains a problem with renderer that doesn't like scaled elements. In order to improve that, I changed skin cable properties (mainly set maxmerge parameter to 1) to get a proper render. This is described here: https://forums.ldraw.org/thread-23006-po...l#pid29747


Attached Files Thumbnail(s)
   

.mpd   Boat.mpd (Size: 62.42 KB / Downloads: 4)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
WeDo - by Philippe Hurbain - 2016-06-05, 16:01
RE: 45300 - WeDo 2.0 - Milo with Tilt Sensor - by Philippe Hurbain - 2021-02-24, 8:41

Forum Jump:


Users browsing this thread: 1 Guest(s)