Correcting 3815, 3816, 3817 (Minifig Hips & Legs)


Leg Measurements
#3
Magnus Forsberg Wrote:But IMO the circular section of the leg has to be of the exact same size as the crutch in the hip, r=9 ldu (trans green cyli)

I measured the length of the foot with a vernier caliper. It is 8mm long (20 LDU). The circular section of the leg has a diameter of 7mm (17.5 LDU).
The circular section is centered with a resulting radius of 8.75 LDU... There is a slope on every minifig leg back. Don't worry it is just 0.045mm width per 1mm height.

Rise = 11mm
Run = 0.5mm

Slope = Rise / Run
Slope = 2200%

The slope is hard to spot with the human eye on a real pair of minifig legs.
The computer works like a magnifying glass. With very high zoom and bad aliasing you will see the slope blindingly easy.

edit: On the real part there is a small line parallel to the slope on each side. This small line makes the illusion perfect, as you can see here https://ministryofminifigures.files.word...erman3.jpg
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Leg Measurements - by Nils Schmidt - 2015-11-24, 18:04
Re: Leg Measurements - by Max Martin Richter - 2015-11-24, 19:31
Re: Leg Measurements - by Magnus Forsberg - 2015-11-24, 21:50
Re: Leg Measurements - by Nils Schmidt - 2015-11-26, 19:05
RE: Leg Measurements - by Chris Dee - 2020-05-30, 19:41
RE: Leg Measurements - by Magnus Forsberg - 2020-05-31, 9:52
RE: Leg Measurements - by Chris Dee - 2020-05-31, 10:56
RE: Leg Measurements - by Magnus Forsberg - 2020-05-31, 11:49
RE: Leg Measurements - by Magnus Forsberg - 2020-06-01, 17:54
RE: Leg Measurements - by Willy Tschager - 2020-05-31, 16:02
Minifig Hips - by Nils Schmidt - 2015-11-30, 22:27

Forum Jump:


Users browsing this thread: 2 Guest(s)