The 64-character limit is still in effect. The part review process will occasionally allow parts to slip through that don't conform to the official specs. All efforts are made to prevent this (including the parts admin final review requirement), but it does occasionally happen. Hopefully the parts in question aren't yet certified (although even if they are, they can still be fixed before being released).
LDraw.org Discussion Forums
›
Models and Parts
›
Parts Authoring
Description Length still constrained to 64 characters?
Description Length still constrained to 64 characters?
Description Length still constrained to 64 characters?
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Description Length still constrained to 64 characters? - by Greg Teft - 2011-11-30, 6:28
Re: Description Length still constrained to 64 characters? - by Travis Cobbs - 2011-11-30, 7:14
Re: Description Length still constrained to 64 characters? - by Jean-Philippe Ouellet - 2011-11-30, 7:36
Re: Description Length still constrained to 64 characters? - by Philippe Hurbain - 2011-11-30, 7:50
Problem with PT "File Check" tool? - by Jean-Philippe Ouellet - 2011-11-30, 15:14
Re: Problem with PT "File Check" tool? - by Philippe Hurbain - 2011-11-30, 15:32
Re: Description Length still constrained to 64 characters? - by Chris Dee - 2011-11-30, 20:07
Re: Description Length still constrained to 64 characters? - by Greg Teft - 2011-12-01, 2:26
|
Users browsing this thread: 1 Guest(s)