The Bricksperience


Re: The Bricksperience
#5
I need to recreate each part because of three reasons:
1. Performance - these parts have a much lower polygon count which is needed for a steady framerate (all the shading and lighting performs different than all the LDraw software).
2. Contours - without contours you couldn't recognize which brick goes where when there are two next to each other.
3. The engine - there is no good possibility to generate a mesh at runtime from external files. I could write a dat to fbx converter but I doubt it'll turn out well as the mesh export functions from LDView and LeoCAD don't work that welll either (flipped normals).
Reply
« Next Oldest | Next Newest »



Messages In This Thread
The Bricksperience - by Matthias Deinert - 2015-05-18, 22:48
Re: The Bricksperience - by Merlijn Wissink - 2015-05-19, 7:22
Re: The Bricksperience - by Matthias Deinert - 2015-05-19, 10:34
Re: The Bricksperience - by Matthias Deinert - 2015-05-19, 14:09
Re: The Bricksperience - by Ben Supnik - 2015-05-20, 2:01

Forum Jump:


Users browsing this thread: 1 Guest(s)