Connectivity Part 50: Travel Limits


Re: Connectivity Part 50: Travel Limits
#4
Ben Supnik Wrote:The motivation to have rotation limits would be to get exact limits for absolute limits (e.g. a 1x4 hinge brick - it goes 0-180 degrees, end of story).

Yes but that information is at the combined level of those two sub parts, it's basically specific joint info.

How would you go define limits in the two loose parts? Like I wrote "those local limits are usually non existent as they would be completely depended on (very detailed) bounding box information."

Or do you want to include joint info by setting up a table instead of adding info at the .dat level?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Connectivity Part 50: Travel Limits - by Roland Melkert - 2015-02-08, 20:31

Forum Jump:


Users browsing this thread: 1 Guest(s)