JBrickBuilder connection model


Re: JBrickBuilder connection model
#50
Ben Supnik Wrote:Does anyone have examples where this is necessary even if primitives are only used for their canonical purposes?
It's needed with things like the axlehole primitive if you keep track of 'slide' limits. The primitive it self is open ended but it might be used in e.g. a motor drive axle which is not (e.g. 71427c01).

Also I sometimes just flush all inherited info in certain (more complicated) parts in order to redo it in a more organized / readable way. For example 43123.dat which also uses a complete pin part in a 'static' way meaning those pins should no longer connect on one side.

See attached snap info for those two parts.


Attached Files
.dat   71427c01.dat (Size: 494 bytes / Downloads: 0)
.dat   43123.dat (Size: 1.33 KB / Downloads: 0)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: JBrickBuilder connection model - by Roland Melkert - 2015-02-09, 23:03

Forum Jump:


Users browsing this thread: 3 Guest(s)