Auto correcting (some) defects in the official library


Re: Auto correcting (some) defects in the official library
#20
Quote:NOCLIP is presently in BFC specification, does this means that we should change spec?
No, those errors are the result of the bfc implementation (clipping on/off at part level) I choose for LDCad it's not a line formatting error. The above log chunk are all >=warning messages while reading the entire (corrected) library, most of them are unrecoverable malformed lines though.

Quote:By hand, no, but I would appreciate if all parts with "obvious" errors were automatically corrected!
I did also a test leaving out the case mismatch only files which resulted in ~300 files, which might be a more manageable chunk.

I'll compile zip files with the clanged files (one with the cap change only files, and one with the rest) later tonight so people can take a look them selves.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Auto correcting (some) defects in the official library - by Roland Melkert - 2014-11-17, 17:47

Forum Jump:


Users browsing this thread: 2 Guest(s)