Stud Groups


Stud Groups
#1
Tim Gould asked that we come up with an official policy for Stud Groups. Unless I'm misunderstanding, he believes that stud groups of arbitrary X by Y dimensions should be created to fulfill the needs of any individual part, and others disagree.

I personally would lean towards restricting stud groups to 1xX, Xx1, and XxX (square). Most existing plates could be accommodated with at most three stud groups. However, I'm not a parts author, so I don't feel that my opinion on this should carry as much weight as part authors (both here on the LSC and not). Also, I agree with Tim that since there is disagreement about these among existing parts authors, it's better for us to set a standard (either direction) than to leave things like they are now.

Given that this affects parts authors, I invite all parts authors with an opinion on the issue to chime in on Tim's thread, to hopefully help us in our decision-making.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Stud Groups - by Travis Cobbs - 2011-11-15, 17:17
Re: Stud Groups - by Roland Melkert - 2011-11-15, 19:59
Re: Stud Groups - by Allen Smith - 2011-11-16, 3:31
Re: Stud Groups - by Willy Tschager - 2011-11-23, 16:39
Re: Stud Groups - by Travis Cobbs - 2011-11-23, 18:26
Re: Stud Groups - by Roland Melkert - 2011-11-23, 19:29
Re: Stud Groups - by Willy Tschager - 2011-11-24, 11:18
Re: Stud Groups - by Chris Dee - 2011-11-24, 12:50
Re: Stud Groups - by Travis Cobbs - 2011-11-28, 22:59
Re: Stud Groups - by Willy Tschager - 2011-11-30, 21:08
Re: Stud Groups - by Travis Cobbs - 2011-11-30, 22:45
Re: Stud Groups - by Chris Dee - 2011-11-30, 23:16
Re: Stud Groups - by Travis Cobbs - 2011-11-30, 23:36
Re: Stud Groups - by Willy Tschager - 2011-12-02, 19:47
Re: Stud Groups - by Chris Dee - 2011-12-02, 20:55
Re: Stud Groups - by Roland Melkert - 2011-12-01, 17:55
Re: Stud Groups - by Willy Tschager - 2011-12-04, 16:19
Re: Stud Groups - by Roland Melkert - 2011-12-04, 19:11
Re: Stud Groups - by Travis Cobbs - 2011-12-05, 3:58

Forum Jump:


Users browsing this thread: 1 Guest(s)