Proposal to change points of origin


Re: Proposal to change points of origin
#4
If there is a meta-point on a part that you need noted that is not covered by the origin, you could propose new meta command to annotate points of interest on a part; MLCad's unofficial ROTATION CENTER meta is, I think, an example of this. People seem pretty resistant to adding new meta-commands though.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Proposal to change points of origin - by Ben Supnik - 2014-03-31, 21:23

Forum Jump:


Users browsing this thread: 1 Guest(s)