Roland Melkert Wrote:Joining will only be applied on the segment level, current version will join when the angle between two segments is less then 0.001 RAD, I could make that an option but I don't think it will help with the example hose.
What about a rubber band like this?
![[Image: band.png]](http://s13.postimg.org/o7307ltnb/band.png)
The resolution in the large circle is more than enough, I could even lower it (use larger segment size). But the smaller circle does not look so good, so I should actually reduce the segment size. Don't you think a smaller segment size but a larger joining angle would help?
By the way, setting "max merge" to 0 does not seem to be "unlimited" as the popup hint says. It behaves rather like 2.