Problem creating submodels with Steps using LDCad

[John]

With position you mean the visual xyz location or just the (line) position in the .ldr/.mpd file?

I mean the xyz position.

And I've installed the software on two different computers, and I see the same behavior. It has to be something in the way I'm doing things. But I can't figure out what. I've been struggling with this for a couple of days.

Images before and after. These are from a .mpd file I created entirely in LDCad. The Red and Grey bricks are the two submodels. The only thing I did in between these screens was to insert an empty step in each submodel, then move 2 of the bricks to that step. I Save All and reload to see the "after" image.

Before:



After: