Experimental part snapping in LDCad 1.3


Re: Experimental part snapping in LDCad 1.3
#2
Could you make it an optional feature? These calculations would bring LDCad to its knees when trying to load Datsville. I never was able to get Datsville to load successfully in SR 3D Builder for instance.

Also, it's too bad there is no official library of connection data. That way software makers could pool their efforts.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Re: Experimental part snapping in LDCad 1.3 - by Michael Horvath - 2013-12-11, 23:21
snapping primitives - by Steffen - 2013-12-12, 4:57
Re: snapping primitives - by Ben Supnik - 2013-12-13, 2:27
Re: snapping primitives - by Roland Melkert - 2013-12-13, 18:28
Re: snapping primitives - by Ben Supnik - 2013-12-16, 1:31
Re: snapping primitives - by Roland Melkert - 2013-12-16, 2:27
Re: snapping primitives - by Roland Melkert - 2013-12-12, 18:05
Re: snapping primitives - by Philippe Hurbain - 2013-12-12, 18:53
Re: snapping primitives - by Travis Cobbs - 2013-12-12, 19:01
Re: snapping primitives - by Philippe Hurbain - 2013-12-12, 19:12
Re: snapping primitives - by Roland Melkert - 2013-12-12, 19:24
Re: snapping primitives - by Philippe Hurbain - 2013-12-12, 19:56
Re: snapping primitives - by Michael Horvath - 2013-12-12, 23:06
Re: snapping primitives - by Roland Melkert - 2013-12-12, 21:07

Forum Jump:


Users browsing this thread: 1 Guest(s)