Alignment of part 60616


Re: Alignment of part 60616
#5
Hi Max,

Wait - I think the part is perfectly aligned, but it _does_ need a help tip - but a different help tip. The part appears to require a 32 LDU X offset (as documented in the current part) but then 5 LDU Z offset to align properly.

So I think the help tip just needs to be updated, not reviewed.

Chris: I think the origin is as good as it can be - X and Z are determined by the door's natural rotation, and Y aligns with the modern 1x4x6 frame without offset. (From what I have seen, this is better than past doors, where X and Z are defined by rotation and Y is defined by the door itself, requiring an unnecessary vertical adjustment relative to the frame.)

Reviewers - any chance of getting the 60616 part series re-reviewed if someone can mod the help instructions? I think it's the only "filling" we're missing for the 1x4x6 frame.

Chris: I applied for part authorship a while ago but didn't get a response - should I just resubmit the form?

Cheers
Ben
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Alignment of part 60616 - by Ben Supnik - 2013-10-10, 3:49
Re: Alignment of part 60616 - by Chris Dee - 2013-10-10, 7:52
Re: Alignment of part 60616 - by Ben Supnik - 2013-10-10, 15:15
Re: Alignment of part 60616 - by Ben Supnik - 2014-01-05, 2:26
Re: Alignment of part 60616 - by Chris Dee - 2014-01-05, 13:01
Re: Alignment of part 60616 - by Ben Supnik - 2014-01-05, 22:26
Re: Alignment of part 60616 - by Ben Supnik - 2014-01-14, 2:21

Forum Jump:


Users browsing this thread: 1 Guest(s)