Alignment of part 60616


Alignment of part 60616
#1
Hi Y'all,

I found this comment in the latest unofficial version of 60616.

0 !HELP To place the glass on 30179.dat, have it -32LDU on the X-axis
0 !HELP relative to the door to place it correctly.
0 !HELP Stud is at 57,70,3.75/-3.75

But from what I can tell, to place the part in the newer frame (60596) I need a 5 LDU Z offset. For the older frame (30179) the holes aren't drawn in and I don't have the real part to examine.

Is the help tip wrong? Am I wrong in my estimated alignment? And...is it possible that the part will change its origin before it is made official? (If I have read the tracker properly, the part has one yes vote and just needs a few more votes.)

Cheers
Ben
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Alignment of part 60616 - by Ben Supnik - 2013-10-10, 3:49
Re: Alignment of part 60616 - by Chris Dee - 2013-10-10, 7:52
Re: Alignment of part 60616 - by Ben Supnik - 2013-10-10, 15:15
Re: Alignment of part 60616 - by Ben Supnik - 2014-01-05, 2:26
Re: Alignment of part 60616 - by Chris Dee - 2014-01-05, 13:01
Re: Alignment of part 60616 - by Ben Supnik - 2014-01-05, 22:26
Re: Alignment of part 60616 - by Ben Supnik - 2014-01-14, 2:21

Forum Jump:


Users browsing this thread: 2 Guest(s)