Ball bearing


Ball bearing
#1
Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).

I need this to do instructions to train boogies that use these ball bearings.

Dimensions: 2x5x2.5mm

[Image: ball_bearing.jpg]

Thanks
Knud
Reply
RE: Ball bearing
#2
(2018-11-02, 12:00)Knud Ahrnell Albrechtsen Wrote: Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).
Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)
Reply
RE: Ball bearing
#3
(2018-11-02, 12:22)Philippe Hurbain Wrote:
(2018-11-02, 12:00)Knud Ahrnell Albrechtsen Wrote: Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).
Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)

Hi Philippe
Here is the link:
https://www.ebay.com/itm/401163945360
or:
https://www.ebay.com/itm/10-MR52ZZ-2x5x2...0011.m1850
Reply
RE: Ball bearing
#4
(2018-11-02, 12:22)Philippe  Hurbain Wrote:
(2018-11-02, 12:00)Knud Ahrnell Albrechtsen Wrote: Hi

I know this is an unusual  request, but could you please make a ball bearing part that fits in the hole of a Technic brick and the inner diameter fits to a Train metal axle (part x1687).
Do you have a link to these ball bearings? (I guess they are avalable somewhere on the web?)

Hi again Philippe

Was it something you were interrested in working on?
if yes do you have a status?

Kind Regards
Knud
Reply
RE: Ball bearing
#5
Quote:Was it something you were interrested in working on?
Sorry Knud, completely forgot... It shouldn't prove very difficult to model...
Reply
RE: Ball bearing
#6
(2018-11-20, 10:20)Philippe Hurbain Wrote: [quote pid='29910' dateline='1542707122']
Was it something you were interrested in working on?
Sorry Knud, completely forgot... It shouldn't prove very difficult to model...
[/quote]

No problem

Thanks for working on it.

/Knud
Reply
RE: Ball bearing
#7
Done... No attempt to model the balls themselves as it seems completely sealed.

Anyone thinks it would be worth adding it as a third party part on PT?


Attached Files
.dat   mr52zza.dat (Size: 927 bytes / Downloads: 15)
.dat   mr52zzb.dat (Size: 710 bytes / Downloads: 10)
.dat   mr52zz.dat (Size: 322 bytes / Downloads: 11)
Reply
RE: Ball bearing
#8
(2018-11-20, 12:39)Philippe Hurbain Wrote: Done... No attempt to model the balls themselves as it seems completely sealed.

Anyone thinks it would be worth adding it as a third party part on PT?

I would really like to use this part too... I can't seem to access it. Maybe I am doing something wrong? Never mind... got it!
Reply
« Next Oldest | Next Newest »



Forum Jump:


Users browsing this thread: 2 Guest(s)