change view for instructions - Printable Version +- LDraw.org Discussion Forums (https://forums.ldraw.org) +-- Forum: LDraw Programs (https://forums.ldraw.org/forum-7.html) +--- Forum: LDraw Editors and Viewers (https://forums.ldraw.org/forum-11.html) +--- Thread: change view for instructions (/thread-85.html)

change view for instructions - Scott Classen - 2011-07-25 Hello. How do I change the view of a particular step so that it will show up properly when opened in LPub? Thanks Re: change view for instructions - Orion Pobursky - 2011-07-25 Not quite sure what you're asking here but maybe try adding a ROTSTEP meta command? Now that I look, it seems as if Bricksmith doesn't support this command yet. You can add it in LPub though. Re: change view for instructions - Scott Classen - 2011-07-26 I found it. view model in step mode select step in leftside panel double click then you have all sorts of view option like upside down or backside save file open in LPub and all is good. Re: change view for instructions - Jim DeVona - 2011-07-26 Orion Pobursky Wrote: ------------------------------------------------------- > Not quite sure what you're asking here but maybe > try adding a ROTSTEP meta command? Now that I > look, it seems as if Bricksmith doesn't support > this command yet. You can add it in LPub though. For the record, Bricksmith has supported ROTSTEP since version 2.1. As Scott figured out, the options appear in the Inspector window when you select a step. Re: change view for instructions - Orion Pobursky - 2011-07-26 Ahh. Well I just did a cursory search. Don't use those commands much.