+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Parts Authoring (https://forums.ldraw.org/forum-19.html)
+--- Thread: I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs (/thread-28734.html)
I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs - Peter Grass - 2025-03-18
Is this good enough to get added to the part tracker etc?
https://www.bricklink.com/v2/catalog/catalogitem.page?P=5842#T=C&C=86
This part is in 1 new set: 75429-1 AT-AT Driver Helmet, so far.
RE: I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs - Peter Grass - 2025-03-18
(2025-03-18, 15:19)Peter Grass Wrote: Is this good enough to get added to the part tracker etc?
https://www.bricklink.com/v2/catalog/catalogitem.page?P=5842#T=C&C=86
This part is in 1 new set: 75429-1 AT-AT Driver Helmet, so far.
Ah nevermind I noticed an error.
RE: I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs - Peter Grass - 2025-03-18
OK this one should be right, probably...
RE: I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs - Orion Pobursky - 2025-03-18
(2025-03-18, 17:51)Peter Grass Wrote: OK this one should be right, probably...
Hi Peter. I created an author account for you on tracker. When you're ready, head over there to submit your part. You'll be asked to affirm the CA prior to your first submit.
RE: I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs - Gerald Lasser - 2025-03-18
What editor are you using?