+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Parts Authoring (https://forums.ldraw.org/forum-19.html)
+--- Thread: how (/thread-28356.html)
how - Jeff Jones - 2024-08-02
im doing the ben 10 torso (87843) how would i do the antistud on the ldd mesh its slopped
h.png (Size: 14.51 KB / Downloads: 75)
lddmesh.png (Size: 23.08 KB / Downloads: 75)
image.png (Size: 24.37 KB / Downloads: 75)
RE: how - Magnus Forsberg - 2024-08-02
(2024-08-02, 20:24)Jeff Jones Wrote: im doing the ben 10 torso (87843) how would i do the antistud on the ldd mesh its slopped
Looks like you should use a sloped cylinder. 4-4cyls or 4-4cylse
https://wiki.ldraw.org/wiki/Primitives_Reference#Three_dimensional_2
What size is that cyl? Regular stud? Could you use a stud4s?
RE: how - Jeff Jones - 2024-08-02
stud4s is a good choice but not correct angle
RE: how - Magnus Forsberg - 2024-08-03
(2024-08-02, 21:24)Jeff Jones Wrote: stud4s is a good choice but not correct angle
Then scale it to the wanted angle.
1 16 0 0 0 1 0 0 0 4 0 0 0 1 stud4s.dat
or what ever multiplier you need.