+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Part Requests (https://forums.ldraw.org/forum-30.html)
+--- Thread: Tile 1 x 2 with US Flag (/thread-24078.html)
Tile 1 x 2 with US Flag - Orion Pobursky - 2020-06-04
Since I can't get set 21054 here in North America until July 1st, I'd love if one of the "Rest of the World" folks would take me a high quality photo or scan of this part:
https://rebrickable.com/parts/3069bpr0286/tile-1-x-2-with-us-flag-print/
RE: Tile 1 x 2 with US Flag - Orion Pobursky - 2020-06-05
(2020-06-04, 4:13)Orion Pobursky Wrote: Since I can't get set 21054 here in North America until July 1st, I'd love if one of the "Rest of the World" folks would take me a high quality photo or scan of this part:
https://rebrickable.com/parts/3069bpr0286/tile-1-x-2-with-us-flag-print/
Never mind. I just made it in accordance with the official proportions.
RE: Tile 1 x 2 with US Flag - N. W. Perry - 2020-06-05
(2020-06-05, 4:38)Orion Pobursky Wrote: Never mind. I just made it in accordance with the official proportions.
I was going to say, you could likely grab a vector file from Wikimedia Commons…although it does look like the flag is a tad stretched horizontally in the print. (You know, to scale from the official 10:19 up to 10:20…) ;-)
RE: Tile 1 x 2 with US Flag - Orion Pobursky - 2020-06-05
(2020-06-05, 5:07)N. W. Perry Wrote: I was going to say, you could likely grab a vector file from Wikimedia Commons…although it does look like the flag is a tad stretched horizontally in the print. (You know, to scale from the official 10:19 up to 10:20…) ;-)
With the .5 ldu border it's 19:39 but I fudged the numbers a bit.