+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Official Models (https://forums.ldraw.org/forum-17.html)
+--- Thread: 48168 Technic Turntable Type 2 Top (/thread-23919.html)
48168 Technic Turntable Type 2 Top - Lukkezen - 2020-02-25
Dear designers,
I tried to make a 3D print of 48168 Technic Turntable Type 2 Top.
- Downloaded STL file
- sliced with Cura
Result: the innner circle of the obkect did only stay open when the object balanced on its side. turning it to platform the result was a closed innner gap as you can see in the first two pictures.
- sliced with Slic3r
Result: bad print but gap was open. See next two pictures.
Is this a problem of desig or of my slicer settings?
George