LDraw.org Discussion Forums
59616 - Printable Version

+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Part Requests (https://forums.ldraw.org/forum-30.html)
+--- Thread: 59616 (/thread-23187.html)



59616 - Johann Eisner - 2019-02-01

Hi

Looking for 59616 to complete a model for OMR.
Didn't found the file on digital bricks. :-(

https://brickset.com/parts/design-59616

Regards Johann


RE: 59616 - Willy Tschager - 2019-02-02

(2019-02-01, 19:29)Johann Eisner Wrote: Hi

Looking for 59616 to complete a model for OMR.
Didn't found the file on digital bricks. :-(

https://brickset.com/parts/design-59616

Regards Johann

According to BL this is an alternate number for 57562. Did you check also that?

w.


RE: 59616 - Philippe Hurbain - 2019-02-02

(2019-02-02, 18:22)Willy Tschager Wrote: According to BL this is an alternate number for 57562. Did you check also that?
No better... the other problem is that it's a flexible part, making a correct design even more difficult!


RE: 59616 - Santeri Piippo - 2019-02-03

(2019-02-02, 19:16)Philippe Hurbain Wrote:
(2019-02-02, 18:22)Willy Tschager Wrote: According to BL this is an alternate number for 57562. Did you check also that?
No better... the other problem is that it's a flexible part, making a correct design even more difficult!

I have the part but not at hand. It'll probably take a few months for me to retrieve it. I suppose it needs to be modeled as flexible sections...


RE: 59616 - Gerald Lasser - 2019-02-04

(2019-02-03, 10:50)Santeri Piippo Wrote: I have the part but not at hand. It'll probably take a few months for me to retrieve it. I suppose it needs to be modeled as flexible sections...

I dug out some of mine. Looks like it needs about 10 - 12 flexible sub-parts to construct.

- Start/End Piece
- 5 different Spinal processes
- 4 different traverse processes


RE: 59616 - Johann Eisner - 2019-02-04

(2019-02-04, 7:22)Gerald Lasser Wrote:
(2019-02-03, 10:50)Santeri Piippo Wrote: I have the part but not at hand. It'll probably take a few months for me to retrieve it. I suppose it needs to be modeled as flexible sections...

I dug out some of mine. Looks like it needs about 10 - 12 flexible sub-parts to construct.

- Start/End Piece
- 5 different Spinal processes
- 4 different traverse processes
Will upload the model without the part for this moment.
If the part is available at some point, I will correct the model.