LDraw.org Discussion Forums
Technic 1990 - Printable Version

+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Official Models (https://forums.ldraw.org/forum-17.html)
+--- Thread: Technic 1990 (/thread-18254.html)



Technic 1990 - Max Martin Richter - 2015-12-12

Technic 1990 models


8830 - Rally 6-Wheeler - Max Martin Richter - 2015-12-12

   

Download MPD (OMR compliant)
Known problems: Both 8L Axles of the roll cage are a bit too long (it's slightly stressed in the real model)
Done with LDCad 1.5b1.


Re: Technic 1990 - Philippe Hurbain - 2015-12-13

As you can see the helmet looks rather good Wink


8830 - Rally 6-Wheeler - Race Car - Max Martin Richter - 2015-12-27

   

Download MPD (OMR compliant)
Done with LDCad 1.5b2.


Re: 8830 - Rally 6-Wheeler - Race Car - Philippe Hurbain - 2015-12-27

Looks good at first sight, but it seems that the figure is sitting too straight, bottom back collides with the seat and even bleeds through the back. Now that doesn't bother me a lot Wink


Re: 8830 - Rally 6-Wheeler - Race Car - Max Martin Richter - 2015-12-27

You are right, this problem must occur at the main model as well, cause I copied the figure from there.
I'll correct this ASAP.

/Max


Re: 8830 - Rally 6-Wheeler - Race Car - Stephen - 2015-12-27

Also, the half-bushes on the right-side axle-8 are 1 ldu out of alignment with the connectors, and in comparison to those on the other side.


Re: 8830 - Rally 6-Wheeler - Race Car - Max Martin Richter - 2015-12-28

The figure position and the bushes are fixed.


Re: 8830 - Rally 6-Wheeler - Race Car - Stephen - 2015-12-28

One of the steering-arm pins is higher than the other. Although unlike the other issues it doesn't in any way invalidate the model though - just pointing it out in case the purist in you has the desire to adjust this before it hits the OMR ;-)


Re: 8830 - Rally 6-Wheeler - Race Car - Max Martin Richter - 2015-12-28

Thanks for spotting, if you don't mind, I would like to delete the comments to reduce this thread to it's main subject.

/Max