LDraw.org Discussion Forums

Full Version: Parts we are working on
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14
I will do the new thin 1 x 5 liftarm with axleholes until tomorrow. (At the moment I don't have the part number for it).

/Max
The part is now uploaded. Actually I have used an u-number for it.

/Max
Part is ready:
[Image: 90754.png]


/Max

[sub]edit: partnumber correction in link and picture[/sub]
I will try to find out a bit more about 11610. Especially of the how the stud is mould onto the cone.

/Max
I can not find a part with that number! Where is this number from?
At the moment it's not possible do do this part, cause there are no informations about it in the internet. 2 or 3 pictures but I can't see any dimensions on them.
Sorry...(but I still try to find such a part in the real world)

/Max
I got such a brick today. And I hope, that I find the time to rework it asap.
It is very hard to open. I have no idea how to disassemble it for the moment.
It's opened now. But is very hard damaged at some areas now. This will be the first part I have to throw away without building it into at least one model...

/Max
Any photo of stud side?
Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14