LDraw.org Discussion Forums

Full Version: Are standards for official parts too strict?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
I am OK with this solution. MLCad 3.4 does no longer remove blank lines.
Thanks for mention that.
I just tried version 3.4 of MLCad and it saves also blank lines. So that should not be a problem Smile.
I go ahead and try to change DATHeader now.
In fact DATHeader deleted empty lines in there has been an error with comments detected and you correted them.
While I am currently at this, I think DATHeader should now also "empty" lines that only consists of "0 //".
So the number of lines should not be affected during this operation.

While I am just on the code I also limit the part description to Integer.MaxValue according the call for votes on this issue.
Pages: 1 2