LDraw.org Discussion Forums

Full Version: I made a part 5842 Slope, Curved 2 x 4 with 4 Recessed Studs
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Is this good enough to get added to the part tracker etc?

https://www.bricklink.com/v2/catalog/cat...2#T=C&C=86

This part is in 1 new set: 75429-1 AT-AT Driver Helmet, so far.
(2025-03-18, 15:19)Peter Grass Wrote: [ -> ]Is this good enough to get added to the part tracker etc?

https://www.bricklink.com/v2/catalog/cat...2#T=C&C=86

This part is in 1 new set: 75429-1 AT-AT Driver Helmet, so far.

Ah nevermind I noticed an error.
OK this one should be right, probably...
(2025-03-18, 17:51)Peter Grass Wrote: [ -> ]OK this one should be right, probably...

Hi Peter. I created an author account for you on tracker. When you're ready, head over there to submit your part. You'll be asked to affirm the CA prior to your first submit.
What editor are you using?