LDraw.org Discussion Forums

Full Version: 48168 Technic Turntable Type 2 Top
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Dear designers,

I tried to make a 3D print of 48168 Technic Turntable Type 2 Top.
- Downloaded STL file
- sliced with Cura
Result: the innner circle of the obkect did only stay open when the object balanced on its side. turning it to platform the result was a closed innner gap as you can see in the first two pictures.
- sliced with Slic3r
Result: bad print but gap was open. See next two pictures.

Is this a problem of desig or of my slicer settings?