(2020-01-11, 17:50)Philippe Hurbain Wrote: [ -> ]With the official launch of Spike Prime set, I was asked how to create cables in models... so I made this short video:
https://www.youtube.com/watch?v=vDnkkPsyCT4
This is really helpful, thanks for posting it.
There's something that happens around 2:08 where you generate a new guide point (sorry if that's not the right terminology) and then move it into the part to guide the cable. How does that happen? Seems like a keyboard command?
Thanks,
cj
(2020-01-13, 8:22)Hendrix Wrote: [ -> ]How does that happen? Seems like a keyboard command?
Yes, Insert key. There is a box bottom left showing keyboard keys and mouse actions. When you select any end point of a flex part and press insert key, only the control point is added.
(2020-01-11, 17:50)Philippe Hurbain Wrote: [ -> ]With the official launch of Spike Prime set, I was asked how to create cables in models... so I made this short video:
https://www.youtube.com/watch?v=vDnkkPsyCT4
Nice tutorial.
I noticed you sometimes find the 'umbrella' is in the way. You can hide it at any time with the p (pin) key.
(2020-01-13, 18:35)Roland Melkert Wrote: [ -> ]I noticed you sometimes find the 'umbrella' is in the way. You can hide it at any time with the p (pin) key.
I guess I should use that... but I asked once for the possibility to make the umbrella a ring instead of a disk to make it less covering
(2020-01-11, 17:50)菲利普·胡爾班 Wrote: [ -> ]隨著 Spike Prime 套裝的正式推出，有人問我如何在模型中製作電纜...所以我製作了這個簡短的影片：
https://www.youtube.com/watch?v =vDnkkPsyCT4
Excuse me, may I ask where I can find the Spike controller and motors?