LDraw.org Discussion Forums

LDraw.org Discussion Forums > Models and Parts > MOCs (My Own Creations) > Starfighter with assembly steps
Full Version: Starfighter with assembly steps
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Jim DeVona

2011-12-11, 6:10
Here's an LDraw file for a chunky starfighter I made. It includes assembly steps. I like the aft half of the ship best.

[Image: 5.png]

I'm sure I'm not the only one who uses LDView's fly-through mode to check out the view from the cockpit, right? It's important to make sure your minifig pilots have good visibility for their dogfights.

[Image: 5-fps.png]

(Warning: uses some unofficial parts.)

Jean-Philippe Ouellet

2011-12-11, 6:59
Jim DeVona Wrote:It's important to make sure your minifig pilots have good visibility for their dogfights.
[Image: 5-fps.png]
In that case, may I suggest a rear-view mirror? It's important to be sure nobody's sneaking up at your 6.

Jim DeVona

2011-12-11, 13:52
Ha, very good point!

Greg Teft

2012-03-14, 4:34
NICE! What tool are the screenshots of?

Travis Cobbs

2012-03-14, 4:43
The top one is from Bricksmith, and the bottom one is from LDView (both on a Mac).
LDraw.org Discussion Forums > Models and Parts > MOCs (My Own Creations) > Starfighter with assembly steps