LDraw.org Discussion Forums

Small parts request:

Looking through the inventory of some Minecraft sets and came across the following parts which I couldn't find in the LDraw or Bricklink Studio distributions.

19730 - Minifigure, Headgear Helmet Rectangular (Minecraft)
44567b - Hinge Plate 1 x 2 Locking with 1 Finger on Side without Bottom Groove

The hinge plate is used in two Minecraft sets (21142-1 and 21146-1).  Also found the following cape too, which I will list below for completeness.

bb846 - Minifigure, Cape Cloth, Tattered and Pixelated (Minecraft) - Starched Fabric

Author notes:

(2019-07-19, 22:13)Steve Guidi Wrote: [ -> ]19730 - Minifigure, Headgear Helmet Rectangular (Minecraft)

This is on digital-bricks so can be converted

(2019-07-19, 22:13)Steve Guidi Wrote: [ -> ]44567b - Hinge Plate 1 x 2 Locking with 1 Finger on Side without Bottom Groove

44567, with the groove, is official. I'm kinda shocked that the without groove variant is not even on the PT.

(2019-07-19, 22:13)Steve Guidi Wrote: [ -> ]Small parts request:

The helmet and the hinge are at the Part Tracker now.
The cape however, is a bit more difficult to do, without a good scan of the part. Do you have it?

(2019-07-20, 14:47)Magnus Forsberg Wrote: [ -> ]The helmet and the hinge are at the Part Tracker now.
The cape however, is a bit more difficult to do, without a good scan of the part. Do you have it?

This is the best pic I could find:
https://www.brickowl.com/catalog/lego-minifigure-cloak

(2019-07-20, 14:47)Magnus Forsberg Wrote: [ -> ]The helmet and the hinge are at the Part Tracker now.
The cape however, is a bit more difficult to do, without a good scan of the part. Do you have it?

Thank you for your work on this request!

I don't have the part yet, but I have ordered the sole set that contains it.  I'll post a high resolution photo when I get a chance.

(2019-07-25, 2:32)Steve Guidi Wrote: [ -> ]Thank you for your work on this request!

I don't have the part yet, but I have ordered the sole set that contains it.  I'll post a high resolution photo when I get a chance.

I totally spaced out on this -- sorry for the delay!  High-res photo attached and linked below.  The tick marks at the bottom of the photo are mm markings for size reference.

https://i.imgur.com/oK5tKr0.jpg

(2020-01-25, 1:01)Steve Guidi Wrote: [ -> ]I totally spaced out on this -- sorry for the delay!  High-res photo attached and linked below.  The tick marks at the bottom of the photo are mm markings for size reference.

https://i.imgur.com/oK5tKr0.jpg

OK, I'll do that one...

Done!
https://www.ldraw.org/cgi-bin/ptscan.cgi...0pixelated