LDraw.org Discussion Forums

Full Version: Part request: bfloat2c01, LEGO Boat Hull 25 x 10 x 4 1/3 (from set 4011)
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Dear All,

the following part is missing: bfloat2c01, LEGO Boat Hull 25 x 10 x 4 1/3 (from set 4011)

at least I am unable to find it

Is there anyone who could create it?

Thank you in advance,
Best regards,
Marek Kaminski

PS. and as my gratefulness, I'd like to share with you, when the part is created, a model of my swimming NXT RC trimaran (I miss this one (middle) hull to create its building instructions)
Just downloaded all what's needed and tested in MLcad.

Philo - from my point of view the hull is prepared EXCELLENTLY :-)

Thank You, very, very much once again :-)

PS. To redeem my promise, I'd like to share with the community my MOC [but for now without bfloat2c01 - I'll change this post when the hull is included & the second (upper) part of the MOC is added to below PDF]:

http://mkpk.knot.kudzia.eu/Trimaran/trimaran.pdf ## floating base of my NXT RC catamaran


BTW: the whole description is here (but in Polish): http://www.lugpol.pl/forum/viewtopic.php?p=366710 (but the photos do not need words ;-)
And again - I'll modify this post and link here rebrickable description in English (when ready)
At last! I've finally made it!

anyone who is interested, please, check the result:



that's my NXT RC (over bluetooth) catamaran, using hull digitalized by Philo :-)

Thank You Philo once again :-)
Best regards,
Marek Kaminski