LDraw.org Discussion Forums

I need this for a set of instructions I'm doing. I can do an approximate version that'll be OK, but if someone's already working on them, that'd be hoopy. I don't have the actual part.

Hey Ross,

the part you are looking for is available in the LDD. So I can provide you a raw conversion of the part: HANDLEBAR W/3.2 SHAFT/BAR ENDS.

Rolf

Hi Ross,
Glad to see you here
Working on cleaning...

Here attached (PT is currently down) the cleaned-up version...

Now on PT: http://www.ldraw.org/cgi-bin/ptdetail.cg.../98397.dat