LDraw.org Discussion Forums

LDraw.org Discussion Forums > General > General LDraw.org Discussion > How to use Plist meta-command
Full Version: How to use Plist meta-command
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

Jono

2013-11-24, 7:13
G'day. Not sure if it has been mentioned before but here is my question. I am currently in the middle of making instructions but dont know how to make the 3L technic universal joint appear in Lpub (instruction part count) as a whole part and not 3 seperate parts, but in Mlcad I want to bend it so to speak using the 3 parts that make it up. Could someone show me how to do this in Mlcad step by step begining to end for a novice.
Cheers Jono

Philippe Hurbain

2013-11-24, 16:10
You have to use a LPub SUBST metacommand. See the tutorial here, section 3.5

Jono

2013-11-24, 20:55
That is helpfull. When its time to do the instructions ill follow that guide. Thank you. Cheers Jono
LDraw.org Discussion Forums > General > General LDraw.org Discussion > How to use Plist meta-command